Drinking straw including an ice trapping net

Not Applicable.

Not Applicable.

(D) REFERENCE TO A “SEQUENTIAL LISTING”, A Table, Or A Computer Program Listing APPENDIX SUBMITTED ON A COMPACT DISC (See 37 CFR 1.52(e) (5).

Not Applicable.

Not Applicable.

(1) Field of the Invention:

Not Applicable.

(2) Description of the Related Art including Information Disclosed under 37 CFR 1.97 and 1.98:

Not Applicable.

The invention includes a drinking straw with an inverted funnel-shaped net retained near a lower end of the straw. The net traps ice at the lower end of the straw to cool liquid drawn into the lower end of the straw.

FIG. 1 shows the 5 steps necessary to put the drinking straw and ice trapping net assembly together;

FIG. 2 shows the top view of the straw (A), the bottom snug rubber washer (B), the plastic net (C), the top snug rubber washer (D), the drink lid (E), and soft-drink cup (F);

FIG. 3 shows the side view of the straw (A), the bottom snug rubber washer (B), the plastic net (C), the top snug rubber washer (D), the drink lid (E), and soft-drink cup (E);

FIG. 4 shows the process in which the ICE-TRAP traps the ice and a KEY to help the viewer identify the different parts of the invention.

The drinking straw and ice trapping net are assembled as follows:

Step 2: stretch a snug rubber washer (B), around the straw, and then slide the snug rubber washer (B), approximately two inches from the bottom of the straw;

Step 3: take a plastic net (C), and allow the top end of the straw (A), to pass through the middle of it until the snug rubber washer (B), stops it at the lower end of the straw;

Step 4: place the snug rubber washer (D), around the top end of the straw (A), like step three, except slide it down the straw (A), until it is about an inch above the plastic net;

Step 5: puncture the drink lid (E), through the bottom with the top end of the straw (A), then take the entire assembly with the lid (E), and place it in the soda drink cup and watch it capture the ice and bring with the ice with the lower end of the straw to the bottom of the cup.

FIG. 4 shows the initial plunge of the assembly into the fluid and ice, immediately trapping ice as the straw makes it decent to the bottom of the cup. FIG. 4 also shows the ice trapped in the plastic net while the rest of the ice floats on the top distant from the end of the straw. Finally, FIG. 4 shows the assembly resting at the bottom of the drink insulated by the cold ice trapped around the lower end of the straw.